syslog-ng documentation

Your main source of knowledge

The syslog-ng product family has an extensive documentation, covering everything from how to install a product to the most complex configuration and settings descriptions. If you cannot find an answer to your question, try the mailing list - our community is always eager to help.

syslog-ng Open Source Edition


11.2.4. Creating custom SDATA fields

If you use RFC5424-formatted (IETF-syslog) messages, you can also create custom fields in the SDATA part of the message (For details on the SDATA message part, see Section, The STRUCTURED-DATA message part). According to RFC5424, the name of the field (its SD-ID) must not contain the @ character for reserved SD-IDs. Custom SDATA fields must be in the following format:<private enterprise number>.field-name, for example, .SDATA.mySDATA-field-group@18372.4.mySDATA-field. (18372.4 is the private enterprise number of Balabit SA, the developer of syslog-ng OSE.)

Example 11.24. Rewriting custom SDATA fields

The following example sets the sequence ID field of the RFC5424-formatted (IETF-syslog) messages to a fixed value. This field is a predefined SDATA field with a reserved SD-ID, therefore its name does not contain the @ character.

rewrite r_sd {
    set("55555" value(".SDATA.meta.sequenceId"));

The next example creates a new SDATA field-group and field called custom and sourceip, respectively:

rewrite r_rewrite_set {
    set("${SOURCEIP}" value(".SDATA.custom@18372.4.sourceip"));

If you use the ${.SDATA.custom@18372.4.sourceip} macro in a template or SQL table, its value will be that of the SOURCEIP macro (as seen on the machine where the SDATA field was created) for every message that was processed with this rewrite rule, and empty for every other message.

You can verify whether or not the format is correct by looking at the actual network traffic. The SDATA field-group will be called custom@18372.4, and sourceip will become a field within that group. If you decide to set up several fields, they will be listed in consecutive order within the field-group's SDATA block.