8.3. Using disk-based and memory buffering
The syslog-ng Premium Edition application can store messages on the local hard disk if the destination (for example, the central log server) or the network connection to the destination becomes unavailable. The syslog-ng PE application automatically sends the stored messages to the destination when the connection is reestablished. The disk buffer is used as a queue: when the connection to the destination is reestablished, syslog-ng PE sends the messages to the destination in the order they were received.
Disk-based buffering can be used in conjunction with flow-control. For details on flow-control, see Section 8.2, Managing incoming and outgoing messages with flow-control.
The following destination drivers can use disk-based buffering:
tcp6() destination drivers can also use disk-based buffering, except when using the
udp transport method. (The other destinations or protocols do not provide the necessary feedback mechanisms required for disk-based buffering.)
Every such destination uses a separate disk buffer (similarly to the output buffers controlled by
log-fifo-size()). The hard disk space is not pre-allocated, so ensure that there is always enough free space to store the disk buffers even when the disk buffers are full.
If syslog-ng PE is restarted (using the /etc/init.d/syslog-ng restart command, or another appropriate command on your platform), it automatically saves any unsent messages from the disk buffer and the output queue. After the restart, syslog-ng PE sends the saved messages to the destination. In other words, the disk buffer is persistent. The disk buffer is also resistant to syslog-ng PE crashes.
The syslog-ng PE application supports two types of disk buffering: reliable and normal. For details, see Section 8.3.1, Enabling reliable disk-based buffering and Section 8.3.2, Enabling normal disk-based buffering, respectively.
Output queue: Messages from the output queue are sent to the destination (for example, your central log server). The syslog-ng PE application puts the outgoing messages directly into the output queue, unless the output queue is full. By default, the output queue can hold 64 messages (you can adjust it using the
Disk buffer: If the output queue is full, disk-buffering is enabled, and
reliable()is set to
no, syslog-ng PE puts the outgoing messages into the disk buffer of the destination. (The disk buffer is enabled if the
disk-buffer()option is configured.)
Overflow queue: If the output queue is full and the disk buffer is disabled or full, syslog-ng PE puts the outgoing messages into the overflow queue of the destination. (The overflow queue is identical to the output buffer used by other destinations.) The
log-fifo-size()parameter specifies the number of messages stored in the overflow queue. For details on sizing the
log-fifo-size()parameter, see also Section 8.2, Managing incoming and outgoing messages with flow-control.
Using disk buffer can significantly decrease performance.
mem-buf-size() option determines when flow-control is triggered. All messages arriving to the log path that includes the destination using the disk-buffer are written into the disk-buffer, until the size of the disk-buffer reaches (
mem-buf-size()). Above that size, messages are written into both the disk-buffer and the memory-buffer, indicating that flow-control needs to slow down the message source. These messages are not taken out from the control window (governed by
log-iw-size()), causing the control window to fill up. If the control window is full, the flow-control completely stops reading incoming messages from the source. (As a result,
mem-buf-size() must be at least as large as